Motorola RM

2. Unplug any cables (power supply or USB cables) from the SUCs. Plug one side of the cloning cable mini USB connector to the first SUC and the other end to the second SUC. During the cloning process, no power is being applied to the SUC. The batteries will not be charged. Only data communication is being established between the two radios. Turn ON the Target Radio and place it into one of the SUCs. For the Source Radio, power ON the radio with the following sequence: • Press the PTT button and the SB2 button simultaneously while turning the radio ON. • Place the Source Radio in its SUC. Press and release the SB1 button. 6. Wait 3 seconds before releasing the buttons and you hear a distinctive audible tone saying the word “Cloning”. 3. Note: 4. 5.

“successful” (cloning is successful) or “fail” (cloning process has failed). If the Source Radio is a display model radio, it will either show ‘Pass’ or ‘Fail’ on the display (a tone will be heard within 5 seconds). Once the cloning process is completed, turn the Radios OFF and ON or, long press the PTT button to exit the ‘cloning’ mode. What To Do If Cloning Fails The radio audible voice will announce “Fail” indicating that the cloning process has failed. In the event that the cloning fails, perform each of the following steps before attempting to start cloning process again: 1. Ensure that the batteries on both radios are fully charged. 2. Check the cloning cable connection on both SUCs. 3. Ensure that the battery is engaged properly on the radio. 8.

PROGRAMMING FEATURES

7.

When the cloning is completed, the Source Radio audible voice will announce either

46

English